欢迎访问机床与液压官方网站!

咨询热线:020-32385312 32385313 RSS EMAIL-ALERT
外圆锥检测装置设计与测量方法研究
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

浙江省教育厅高等学校访问工程师校企合作项目(FG2014118);绍兴市科技局公益性技术应用研究计划项目(2014B70023)


Outer Taper Detection Device Design and Measurement Method Research
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    在外圆锥检测时往往采用接触式和非接触式两种方式进行精度的检验与分析,以上检测方式针对现场检测的较少。设计一个采用非接触方式的外圆锥检测装置,以横剖面法为基础,采用同步数据和定位传感系统进行外圆锥数据的采集,通过A/D转换和数据运算处理后得到外圆锥类零件截面直径、圆锥角以及圆度误差等测量要素,通过实验分析完全能够满足外圆锥类零件现场检测的需要。

    Abstract:

    Usually,contact and non-contact ways are adopted to test and analyze the accuracy in outer cone detection,but it is less for on-site test.A non-contact way outer cone detection device was designed.Based on cross section method,synchronous data and positioning sensor system were used to complete data acquisition.The cross-section diameter of the outer cone-shaped parts,the angle of the cone and the roundness error were obtained by A/D conversion and data processing.The device can satisfy the need of onsite inspection of outer cone through experimental analysis.

    参考文献
    相似文献
    引证文献
引用本文

王卫东,李海清,王坚锋.外圆锥检测装置设计与测量方法研究[J].机床与液压,2018,46(8):140-142.
. Outer Taper Detection Device Design and Measurement Method Research[J]. Machine Tool & Hydraulics,2018,46(8):140-142

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2018-05-16
  • 出版日期: