欢迎访问机床与液压官方网站!

咨询热线:020-32385312 32385313 RSS EMAIL-ALERT
线切割参数对20Cr材料去除率的影响及预测模型建立
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Influence of WEDM Parameters on Removal Rate of 20Cr Material and Prediction Model Establishment
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    为研究中走丝条件下,电火花线切割参数对渗碳钢20Cr材料去除率的影响,设计多因素正交试验。采用极差分析方法对线切割参数脉宽、脉停、电流进行优化,并利用最小二乘法建立材料去除率预测模型。试验结果表明:对材料去除率影响最大的因素是电流,其次是脉停;材料去除率线切割参数最优组合为脉宽40 μs、脉停175 μs、电流6 A;通过最小二乘法成功建立了材料去除率理论模型。试验结果为提高实际线切割20Cr材料加工效率提供了理论基础

    Abstract:

    In order to study the effect of WEDM parameters on the removal rate of carburized steel 20Cr under the condition of medium speed wire walking, a multifactor orthogonal experiment was designed. The range analysis method was used to optimize the pulse width, pulse stop and current of the WEDM parameters, and the material removal rate prediction model was established by using the least square method. The results show that current is the most important factor affecting material removal rate, followed by pulse stop; the optimal material removal rate parameters combination is: the pulse width is 40 μs, the pulse stop is 175 μs and the current is 6 A. The theoretical model of the material removal rate was established successfully by using the least square method. The experimental results provide a theoretical basis for improving the machining efficiency of 20Cr material

    参考文献
    相似文献
    引证文献
引用本文

杨凤双,张鹏,李未,石迎雨.线切割参数对20Cr材料去除率的影响及预测模型建立[J].机床与液压,2020,48(21):101-104.
YANG Fengshuang, ZHANG Peng, LI Wei, SHI Yingyu. Influence of WEDM Parameters on Removal Rate of 20Cr Material and Prediction Model Establishment[J]. Machine Tool & Hydraulics,2020,48(21):101-104

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2021-02-20
  • 出版日期: