文章摘要
顾波,王娇,白晶.基于热连轧机厚度精度的最优控制研究[J].机床与液压,2018,46(8):126-128
基于热连轧机厚度精度的最优控制研究
Optimal Control of Thickness Accuracy of Hot Rolling Mill
  
DOI:10.3969/j.issn.1001-3881.2018.08.034
中文关键词: 预测外推  改进型Smith算法  模糊PID参数自调整  最优控制  热连轧机
英文关键词: Predicted extrapolation data processing  Improved Smith algorithm  Fuzzy-PID parameter self-tuning  Optimal control  Hot rolling mill
基金项目:沈阳科技学院校内科研项目2015-2017(G-2015-06);吉林省2011-2013年科技发展重点基金资助项目(201105041)
作者单位E-mail
顾波 沈阳科技学院信息与控制工程系 281675294@qq.com 
王娇 沈阳科技学院信息与控制工程系  
白晶 沈阳科技学院信息与控制工程系  
摘要点击次数: 48
全文下载次数: 
中文摘要:
      热连轧机AGC系统机制复杂,具有高度非线性、时变性和纯滞后等特点。对上述问题采用最优控制策略:先对Mornitor-AGC闭环反馈检测产生的纯滞后进行预测外推处理,剩余部分的滞后时间采用改进型Smith预估算法和Fuzzy PID参数自调整反馈控制,同时引入GM-AGC的前馈预控,减轻了复合控制中反馈调节的负担。仿真结果表明:在厚控系统中发生20%干扰的情况下,系统动态响应速度快,调节时间短,几乎没有超调量。其成果对有色、冶金行业提高带材质量的工程化具有重要的推广和实用价值。
英文摘要:
      The AGC system of hot strip mill is very complex,and it has the characteristics of high nonlinearity,time variation and time delay.The optimal control strategy was adopted for the above mentioned problems.The predicted extrapolation algorithm was used to solve the pure lag problem that caused by Mornitor-AGC detection,the remaining part of the lag time was improved by using Smith estimation algorithm and Fuzzy-PID parameters self-tuning feedback control.At the same time,the introduction of GM-AGC feedforward control,reduced the burden of feedback regulation.Simulation results show that in the case of 20% interference,the dynamic response of the system is fast,the adjusting time is short,and almost no overshoot.It give practical value to improve the strip quality in nonferrous and metallurgy industry.
查看全文   查看/发表评论  下载PDF阅读器
关闭

分享按钮